24VDC TO 12VDC VOLTAGE CONVERTER

These units are IP53, so there are no ventilation holes to permit stray objects, dust or water droplets to enter the case, there are no external fuses to be tampered with. Fuses will only blow if there is a fault so there is no need to make them accessible.

Many PowerVerters and DD Series products can be configured with alternative output voltages etc. for specialist applications.

All the units consume an off load current of less than 15mA, which is probably less than the self discharge current of the vehicle’s battery. In most cases this can be ignored, speeding the installation by removing the need to fit a remote switch.

TECHNICAL DATA

• Input voltage range: 17-32Vdc
• Output: 13.6Vdc +15% -20% at extremes of temperature, load, etc.
• Intermittent output power: 6A/10A non-isolated, taken for a maximum of 2 minutes followed by 8 minutes rest
• Electrostatic voltage protection: Meets ISO10605, ISO14892, >8kV contact, 15kV discharge
• Output noise: lesss than 50mV
• Power conversion efficiency: Typically 90% for non-isolated units
• Connections: Four 6.3mm push-on flat blade connectors, *5 way Phoenix connector including enable on/off terminal and mating half
• Mounting method: ‘Click ‘n’ fit mounting clip, fitted separately using three hole fixture, *4 hole cradle
• Approvals: 2014/30/EU The general EMC directive, Regulation 10 The automotive directive,93/68/EEC The CE marking directive
• Designed to: EN50498, ISO 7637-2, ISO 11452-1, ISO 14982, EN12895, EN60945, EN55022, FCC15B
• Markings: CE and E (automotive) marked.
• Dimensions: 89x87x50mm
• Weight: 250g