TIGERTRONICS SIGNALINK SL-USB-HTY SOUND CARD INTERFACE

Tigertronics SignaLink USB for Yaesu HTs that use 4-Pin TRRS

The SignaLink USB p/n SLUSBHTY is compatible with various Yaesu HTs that use a 4-pin TRRS Mic/Speaker plug. This includes but is not limited to the radios listed below. The recommended Plug & Play Jumper Module for this configuration is p/n SLMODHT. Please note that you must use this jumper module, or install your own resistor and capacitor as noted on the supplied cable document (the resistor and capacitor are requried by the Yaesu HT).

Compatible Yaesu Radios:

FT-60, FT-60R, VX-1R, VX-2R, VX-3R, VX-5R, VX-110, VX-150, VX-160, VX-230, FT-250R, VX-350, VX-410, VX-420, VX-420A, FT-1DR, FT-1D, VX-8GR

NOTE: If you have Yaesu's CT-131 adapter, then you can also use this cable with the VX-8R, VX-8DR and VX-8RE.

SignaLink USB Interfaces support all computer program digital modes and digital voice modes, WITHOUT using your computer sound card!

Convenient front panel controls let you adjust your Transmit Audio, Receive Audio and Transmit Delay "on the fly", making operation easy. Tigertronics SignaLink USB Interfaces have a state-of-the-art, built-in, low-noise analog-to-digital sound chip, only one USB connection to the computer and, typically, only one connection to the radio. They are fully isolated and compatible with ALL radio Mic, Accessory, and Data ports. The USB cable is included for connection of the SignaLink USB Interface to your computer

Just order the correct combo package of the SignaLink USB Interface and Interface Cable for your radio. On the left of your screen, simply select by radio manufacturer and model, or connector type. Click the "See All" link to open a complete listing of radios supported. Installation of the Tigertronics is a snap, especially if you add an optional Plug-N-Play jumper module that matches your interface and cable selection.