Manufactured by Vibroplex, under the EndFedz brand, these antennas are easy to install, resonant on 8 bands and DO NOT require a tuner to operate. With a power handling of 1 kW (I.C.A.S) they will handle enough power for the majority of Amateurs.

This is an End-Fed Half-Wave antenna for 80/40/30/20/17/15/12 and 10 m bands. Unlike many END FED antennas on the market, this one should not require the Antenna Tuner to use it on most bands. It is resonant Half wave on 80 m (3.5 MHz) therefore also resonant on second, third and fourth harmonics etc.

Due High Impedance feed point, the antenna is less height dependent. You can put it up at 10 or 50 feet in the air, as an inverted Vee, or inverted L  without much change in VSWR values.

Grounding at the transformer box or end of the coaxial cable is recommended for protection of your equipment from an electrostatic build up and discharge.  NOTE: grounding does not affect antenna tuning.

Multi-band Par End-Fedz antennas are a full-length half wave dipoles at their lowest frequency of operation, but with an important difference.

The coax connector is at one end of the dipole, where it is convenient to feed, leaving just a low profile wire to run down the garden. These antennas can be mounted horizontally, vertically or as a sloper.

No ground plane or counterpoise is needed. Portable operation could not be easier. Simply hang the far end from a tree limb - the coax is at the bottom.

Hang it down from a hotel window or string it up in various configurations to fit your needs.

End insulators are supplied making suspension easy.

Features

• Multi band End Fed Half Wave Antenna
• This antenna is resonant on 80/40/30/20/17/15/12/10m
• NO TUNER needed
• Power Handling 1 Kw  (I.C.A.S.)  (350 W data modes)
• NO counterpoise needed although Grounding recommended
• Frequency coverage: 3.5-30 MHz
• Resonant on 80/40/30/20/17/15/12/10 m
• Wire length: 39.6m (130 ft)
• Power Handling: 1 kW (Intermittent Commercial and Amateur Service)
• Stainless Steel hardware