Specifications: Built-in power supply and antenna selector Dimensions. W32 H13 D36 cm（L12.59”×H5.11”×D14.17”） Weight 9.6 Kg（21.16bs） Colour Screen: 12.7cm by 8.89cm（5 inch), resolution 800×480, 65K, 16 Bit RGB Displays Multiple Parameters, Status, PEP output, PA Voltage, PA Current, Power Gain, Temperature, SWR, Frequency and Band Connects to all Transceivers easily with RF Sensing for Band selection and control Frequency Coverage 1.8 Mhz to 50 Mhz including WARC Bands Power Output 600W PEP SSB, 50Mhz output 500W PEP Clean and low distortion output using single 1200w MOSFET Spurious emission less than – 60 dB (50 MHz – 65 dB) Third order distortion (Double Tone Test) 36 dB (typical) Input 50 ohm Unbalanced Matching with SWR less than 1.8:1 4 SO239 Antenna Connectors Comprehensive Protection Systems including Temperature, Voltage, Current, Reflection, SWR, PW and VRF Maximum Values, Overdrive and Open/ Short Circuit Protection Quiet Operation with large heat sink and near silent cooling fan Easy to Maintain Hardware warnings stored internal to Amplifier using no volatile memory Power Supply Voltage Range (100 to 250v), Limited inrush current and pure sinusoidal, Automatic Power Factor correction (PFC) Rear mounted RS232 Port for remote control Supplied with carry bag designed for field operation