Plug the probe’s two-pin connector in to the right hand two pins (closest to the LEDs) of the three available pins in the cover slot. It does NOT make any difference which way it goes in as long as it is plugged in to the far right two pins. The extra pins are for future options. Do NOT remove the blue jumper.

With a temperature probe connected to the CBA, go to "Edit", "Calibrate Temperature Probe" and in either deg C, or F, type in your reference temperature reading and push OK. Note: As long as you do not change to a different CBA or temperature probe you should not have to calibrate the probe again. Also note that this option will be grayed out if the probe is not connected.

The CBA may be set for automatic over temperature cutoff. Place the probe on the battery. Go to “Edit” “Preferences” and check the check box next to “Stop test when battery reaches ? deg”. The default cutoff is140 deg. F or 60 deg C which should be safe for most battery types, be careful if you choose a higher temperature cutoff.

DO NOT continue a test if the "Temp:" indication reaches or exceeds the maximum temperature specification for the battery being tested.